Power Vents Troubleshooting Tips
Latest Power Vents Troubleshooting Tips Articles
-
The power fan should be installed a few feet below the peak of the roof centered on the roof as best as possible. If multiple power fans are being installed because of the roof’s large attic
...Generally, if standing outside while the wind is blowing the turbines should be spinning. If the turbines spin by hand but not in the wind then the bearings are probably too tight. If it's an
...The thermostat control on a power attic ventilator monitors the attic solely for temperature or heat buildup. Thus, the power vent will only run in the hot summer months. During the winter,
...Air Vent gable-mount power attic ventilators are meant for attic spaces in residential houses. The reason they will not usually work in an open space is the power vents need an outside flow of
...The motor on Air Vent power vents is not closed, which means chemicals could affect the motor. Air Vent recommends not using power vents around chemicals.
Set the humidistat higher. The numbers on the humidistat control run from 1 to 9, which is 10% to 90%. If it's set too low, the power vent will run all the time. Set it around 8.
Check the intake ventilation. Make sure that the attic insulation has not covered the intake vents preventing air from feeding the power vent. It might be necessary to either insert insulation
...
Our exclusive Contractor Locator will allow you to find contractors in your area who can assist with Air Vent product installation—including solar attic fans and skylight tubes. Click the link below to register and get started.
